EARTHQUAKER DEVICES
EarthQuaker Devices Afterneath Enhanced Otherworldly Reverberator
- SKU:
- AFTERNEATHV3
- UPC:
- 810019911729
- Condition:
- New
- Availability:
- Usually Ships Within 24 Hours
- Shipping Weight:
- 3.00 LBS
- Shipping:
- Free Shipping
Afterneath®
Enhanced Otherworldly Reverberator
The Afterneath sounds a lot like it looks – a wizard bursting forth from ethereal cave and ready for the ambient battle. You are the wizard – or sorceress, if you prefer – and the cave is your instrument’s signal, vast, expansive, and magical. Do you go inside? Roll a D20 to proceed!
Once inside, a reflection of light from an unknown source catches your eye, and you notice a bizarre sheen on the walls of the cave. You timidly inch closer to the walls of the cave. Placing your hand gently on the cavern wall, you feel the rock move. The cave is alive! Alarmed, you emit a loud gasp, which reverberates throughout the subterranean landscape. Upon further listening, it appears as though the reverberations of your voice are in fact a swarm of short digital delays which may be used to create wild and cavernous reverbs, or scattered, short, rhythmic delays with bizarre characteristics.
Will you cast “Length,” which controls the decay length of the reverb?
What about “Diffuse,” which adjusts the spread of the reverb? With your wand (or just the knob) turned counterclockwise, the reverb is sharper with more attack, resulting in a stuttering sputter of individual early reflections. Clockwise casts a washy, more ambient-sounding hex.
Overwhelmed by fear, you hastily cast “Dampen!” As you shout the incantation, you notice that a counterclockwise variation of this spell results in brighter tones, while as you rotate your wand clockwise; you hear darker tones with a mellower top-end. It’s almost as if your magic changes the hardness of the cavern walls, and thus the tonal characteristics of the reverb!
Elsewhere in your book of magic is “Drag,” which separates the individual digital delay lines, literally dragging them through the very fabric of time and space towards an unknown event horizon from which they may never return. Clockwise “Drag” positions will gather the delay lines close together for a more reverb-like effect. Turn the “Drag” counterclockwise, and the delay lines will begin to pull apart for a scattered ping-pong delay effect.
The Drag can be put under voltage or expression control using the “EXP” jack located on the side and operates in 9 different modes which are selected by the small “Mode” control. These modes are: Unquantized, Unquantized with slew, Unquantized volt/octave,
Chromatic scale, Major scale, Minor scale, Pentatonic scale, Octaves & fifths and Octaves. These modes drastically change the way the Drag control functions, especially while using an expression control or CV.
The “Reflect” alters the depth of the cave, and with it the regeneration of the reverb. This acts as a feedback control and will self-oscillate if cast by a high-level user. Turn clockwise for more wash and echoes, counterclockwise for less.
Finally, the “Mix” alters the alchemical balance between the input signal and the effect. The Afterneath does not go fully wet but does lower the level of the input signal as you raise this control to create the appearance of a fully wet reverb.
Modes
The Modes control changes the way the Drag control functions. The LED will change colors indicating which mode you are in.
1. Unquantized: Smooth, unquantized response over the operating range
2. Unquantized with Slew: Smooth, unquantized response over the entire operating range, but with a musical slew that is reminiscent of turning the varispeed knob on a vintage British tape delay. The “Drag” will lag behind the knob or cv changes, but then quickly catch up.
3. Unquantized Volt/Octave: Smooth and unquantized, yet scaled to align with the 1v/octave curve to allow melodic modulation of audio in the buffer, or control the frequency of self-oscillation like a voltage controlled oscillator.
4. Chromatic Scale: Quantized 1v/octave to the chromatic scale
5. Minor Scale: Quantized 1v/octave to the minor scale
6. Major Scale (Lydian): Quantized 1v/octave to the major scale (Lydian)
7. Pentatonic Scale: Quantized 1v/octave to the pentatonic scale
8. Octaves & Fifths: Quantized 1v/octave to omit all but octaves and fifths
9. Octaves: Quantized 1v/octave to omit all but octaves
Dimensions: 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
Current Draw: 100 mA
Input Impedance: 1 MΩ
Output Impedance: 500 Ω
Expression Jack
This is an expression pedal control jack for the Drag. The Afterneath requires an expression pedal with a value of 50k, we recommend the Moog EP-3 or similar. While it will work with a standard 10k expression pedal, a 50k expression pedal will allow you to access the full range of each mode.
-
Tip is the wiper, Ring is 5v and Sleeve is ground.
-
You can also use CV with this jack. CV operates 0-5v.
Flexi-Switch® Technology
This device features Flexi-Switch Technology! This electronic switching style allows you to simultaneously use momentary and latching style switching.
-
For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.
-
For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch, the effect will be bypassed.
The Afterneath uses electronic buffered bypass, it requires power to pass signal and the buffer is always active. You may experience a pop the first time the Afterneath is switched on after power up.
Tails / No Tails Switching
The Afterneath is factory set in “tails mode.” This means that the wet signal will naturally decay and slowly fade to silence after the effect is switched off.
To deactivate this feature:
-
Unplug the power cable from the power jack.
-
Hold down the footswitch and insert the power cable.
-
The LED will flash 3 times. You can now release the footswitch.
Follow the same steps to reactive tails mode.
Power
This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!
Shipping
We can ship to virtually any address in the world however our Website is optimized for USA sales. Note that there are restrictions on some products, and some products cannot be shipped to international destinations.
When you place an order, we will estimate shipping and delivery dates for you based on the availability of your items and the shipping options you choose. Depending on the shipping provider you choose, shipping date estimates may appear on the shipping quotes page.
Please also note that the shipping rates for many items we sell are weight-based as well as Distance based and now Dimensional weight based (the actual size of the shipping box) . The weight of any such item can be found on its detail page. To reflect the policies of the shipping companies we use, all weights will be rounded up to the next full pound. Please note that some shipping companies ship by Box Size
We ship primarily through UPS, but can also ship through the United States Postal Service or FedEx at the buyer’s request. For any Worldwide shipments we use UPS or USPS. The shipping price you are charged covers transit, insurance, proper packing, and tracking. If you prefer another shipping method please let us know so we can accommodate your needs. In the event of damage in transit we will help facilitate a claim with the shipping company to ensure full refund.
Returns Policy
We offer a 72 hour approval period on all guitars, amplifiers, and pedals from the date of purchase for in store transactions or date of delivery for internet orders. This approval period is for the buyer to make sure that the instrument is in the condition and originality we advertised. In the event of any return the buyer pays all shipping and insurance costs, both to and from, as well as any other fees associated with the transaction.
You should expect to receive your refund within 2 business days of us receiving your package from the return shipper. This time period does not include the transit time for us to receive your return from the shipper (5 to 10 business days), the time it takes us to process your return once we receive it (1 to 3 business days), and the time it takes your bank to process our refund request (5 to 10 business days).
PLEASE CALL US FIRST at (570) 909-9216 If you need to return an item, You can then simply login to your account, view the order using the "Complete Orders" link under the My Account menu and click the Return Item(s) button. We'll notify you via e-mail of your refund once we've received and processed the returned item.
For logistical reasons we are unable to accept returns or cancellations on any item that was special ordered. All returns must be approved by phone or email and must be returned in the exact condition they left our store. Any item returned not in the same condition it left our store is subject to a 20% restocking fee at our sole discretion. For logistical reasons we are unable to accept returns on any transaction involving a trade, both in store and online. Unauthorized returns will be refused and returned at customer's expense. Please know we go to great lengths to ensure with 100% confidence that you are getting the exact item you purchased in the condition and originality described. We strive to earn your business.
Layaway
We offer a 60 day layaway program for all items in our store. A 20% non-refundable deposit is required and hold the item for up to 60 days. In the event of layaway cancellation, the 20% deposit will be forfeited.
Accepted Methods of Payment
Cash, Visa, Mastercard, Discover, American Express, PayPal and Wire Transfer. If you have any questions regarding payment please ask.